#Down;pad usb 2.0 serial driver install#
Install Motherboard Chipset Serial Drivers Make sure to reboot the machine after installation so any changes can take affect. Make sure that Windows Update is enabled so any Motherboard or USB drivers can be downloaded automatically. There are a few possible reasons why this is happening and you should work through the possible solutions in the following order. If the PC can’t install the drivers for whatever reason the Minimillr will usually appear under the USB section, as “ USB 2.0-Serial” with a yellow exclamation mark. Note that if you unplug the USB cable and re-plug in different USB socket, the driver will allocate a different port number. Make a note of the COM port allocated, as you need to enter this in the software used to control the machine (Candle, Easel etc.) Here, the USB-SERIAL CH340 driver has installed, and allocated COM port 3 to the Minimillr.
![down;pad usb 2.0 serial driver down;pad usb 2.0 serial driver](https://i.ytimg.com/vi/Sw1UZO-lmAE/maxresdefault.jpg)
Click the Windows key and type Device Manager and click to run.Ī successful driver install will look like the screen below. In Windows You can check the status of the a USB device in Device Manager. How do I know if the driver installed and working?
![down;pad usb 2.0 serial driver down;pad usb 2.0 serial driver](https://d3ieau6kif6jv9.cloudfront.net/wp-content/uploads/2014/10/CH340-windows-7-driver.jpg)
Make sure that no other program is locking the serial port, such as the Arduino IDE or 3D printing software such as Cura.
![down;pad usb 2.0 serial driver down;pad usb 2.0 serial driver](https://ae01.alicdn.com/kf/HTB1UBppHh1YBuNjy1zcq6zNcXXaz/The-new-CP2102-module-USB-to-TTL-USB-to-serial-UART-driver-board-STC-download.jpg)
Run setup.exe once downloaded/extracted.Įasel users need to install the Easel Driver as well as the USB>Serial Driver. The driver is available to download here as a ZIP file, and here as an EXE file. In most cases Windows will install the driver. The Minimillr uses an Arduino controller that requires a USB to Serial driver to send and receive commands from your PC.